AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Cgminer 4.9.212/20/2023 However many times we iterate this, we don't seem to end up with an expression that "ontologically commits" us to the counterpart assertion. Is the difference more evidence for distinguishing facts from obtaining states-of-affairs? For example, let X be (1), and then go to X's obtaining. seems to be an invalid expression, if "This" refers to (3) itself.) Kristian Berry Asks: "This state-of-affairs' obtaining" Please could I ask someone to assist me with figuring out what it wrong with this device? I have looked at the logs but I cannot make sense of the logs as I do not know what I am looking for. Also, because CGMiner will not start, the device shows no system status information, I cannot see temperature info, I can't see if the hashboards are okay, I can't tell at all where the proble lies. My concern is that the initial run where it got up to 83 degrees has broken the miner, because it doesn't get hot at all currently. Please see these images, they describe what I am seeing:ġ) The device overview where it shows that CGMiner is waiting to start: ģ) The device status I get when I try start CGMiner vis SSH: Ĥ) The event code error as described above: The only visual feedback I have is from the device overview page which gives me the following error:ĮventCode: E011 EventCause: Slot-0 Zero HS 4500 Seconds EventAction: Zero HS Warning EventCount: 6 LastTime: Thu Dec 7 12:59:42 2017 EventSource: system-monitor The power supply is fine, and the device itself seems fine and I get get into the web interface as well as connect to the device via SSH. The device does not get hot at all currently.Īt that point I only had 1 pool setup, so I added in 3 just to be sure and tried restarting CGMiner but it still didn't work. I then rebooted the box too but that made no difference. I then restarted CGMiner but it would not restart. I changed the pool settings from factory to the pool information using my chosen pool and worker name for the device. Within a few minutes the device had cooled down significantly and the fans sped back up to full speed. The device became very hot, 83 degrees I think it was and then the screaming fans seemed to slow down to a crawl. It looked like CGMiner was running and it was mining. When it arrived, I switched it on and it had 3 mining pools already configured from the factory. I have a WhatsMiner M3 that runs CGMiner 4.9.2. While I respect that, I am struggling with support on my kit and I would really appreciate some assistance if possible. I have tried reaching out for assistance in other Bitcoin forums, to no avail as apparently I have bought miner hardware that is not supported by the people who are responsible for CGMiner software.
0 Comments
Read More
Leave a Reply. |